previously PDCP security (integrity and ciphering) could only
be enabled for both Rx and Tx at the same time.
this, however, caused an issue during the conformance testing in which,
in TC_8_2_1_1() for example, the eNB sends a SecModeCommand and a
RRC Reconfiguration in the same MAC TB. In this case, the eNB
needs to be able to enable DL security right after sending the SecModeCmd
in order to send the RRCReconfig encrypted. However, enabling UL security needs
to be postponed until after the SecModeComplete is received.
This patch allows to enable PDCP security for rx/tx independently if
that is needed. The default way is like before, enabling it for tx/rx at
the same time.
* Remove boost string
* Make sure that int/enc algos can be specified in capital case in the MME.
* Use == instead of compare for comparing strings with const chars
Co-authored-by: Pedro Alvarez <pedro.alvarez@softwareradiosystems.com>
If a process exits and has a controlling terminal, everything under
it gets a SIGHUP by the kernel. That's the case for instance when
running a srsUE over ssh with some specific parameters. As a result,
when the ssh client is killed, SIGHUP is sent to srsUE, which will be
killed immediatelly without proper release, which means in turn that log
buffers are not flushed.
Let's do proper shutdown when SIGHUP is received so that everyone can
get log files.
this commit fixes and issue where, after receiving paging and the resulting
PRACH from the UE, the eNB would create DRB1 and already schedule DL traffic
on this bearer. However, since the UE has not received the reconfig message
yet, the DL traffic is dropped since DRB1 isn't set up yet.
the commit also does not reset the BSR state of the bearer inside MAC since
this caused to a stall of the received DL PDU. The value would initially be set to
a non-zero value (after receiving the DL PDU from EPC). But when the bearer
was (re-)introduced to MAC, it would reset the BSR to zero, and, since
MAC never polls RLC, the PDU wasn't sent down until the next PDU arrives
and sets the BSR to a non-zero value again.
the 6 PRB eNB requires a different PRACH offset than the default
value of 2 in the SIB1 example. In order to avoid having
to use a separate SIB config with just a single different value,
the patch patches the value to the only right configuration, if it's wrong.
It continues operation but still issues a warning so the user
can change it in the config.
this commit removes the getsystime() call from the activity handling.
it uses a single timer per UE to handle its activity.
three different timer values exist. one for the Msg3 reception. This
is like before and is quite low to quickly remove fake UEs from the
RRC. The second is a generic value (set to 1s for now) that covers
the entire UE configuration phase where multiple messages are sent
back and forth until the UE is fully set up and the default
bearer runs. From there on, the UE inactivity timer is used which
may be much bigger than 1s.
there were two defaults and one was shadowing the other. This
commit removes both defaults and uses blocking-mode for RRC
calls to PDCP in the UE. The eNB write_sdu() uses the non-blocking
mode by default. We have to review the eNB's RRC perhaps and use blocking
there too and non-blocking only for data plane
* Clang-formated UE, eNB and lib.
* Fixed compiling errors from clang-format.
* Fix linking issues introduced by clang-format
* Fix poor formating in initializing arrays of arrays.
* Fix mistake in conflict resolution on rm_turbo.c
* Re-apply clang format to gtpc_ies.h